How to create a 3D jewellery set

What you want:

Findings – These can be unique centered on private preferences:

Applications:               

Directions:

1. To start with you will need to have to saw/file the sprue off the sections
2. You can pre buff/ pre polish the star parts which makes cleaning easier following soldering
3. Working with buff sticks to buff back the cast end likely from coarse to great
4. The moment you have bought to fantastic buff paper you can start off to polish utilizing luxi compound –blue for initially stage with the calico mop
5. There are guideline marks on the issue of the star pendant and earrings you want to solder soar rings to
6. You can file bounce rings with triangular file to give them an angle at the finishes so they sit flat in opposition to the stage of the star
7. Apply solder paste the place the tutorial marks are on the stars
8. On the soldering block, drive the leap ring against the stars guideline marks and use tweezers to hold the bounce ring in area
9. Employing the hand torch, warmth up the strong star and once it is starting up to convert colour slowly and gradually go together to the bounce ring so it receives to tempreture at identical time until eventually the solder melts and joins the pieces collectively
10. Quench and set it in pickle, rinse immediately after pickling to wash off acids.
11. If you didn’t buff and pre polish earlier now you will need to buff back again the cast end and if you will need to remove any additional solder
12. Polish the piece employing luxi compound – blue for initially phase working with a calico mop
13. Then polish with White luxi compound and a fluffy mop
14. For your earrings you can open up up your ear wire and then near it back again collectively
15. For the star pendant necklace, dependent on the bail you pick you can both add it immediately the the leap ring or if necessary you may perhaps need to incorporate yet another smaller jump ring ahead of the bail.
16. Ultrasonic or clean up off any residual polish and incorporate a chain to the pendant.

Optional: you can either wholly near your conclusions by soldering them during soldering stage 9 or leave the conclusions semi open and just pushed collectively .

Conserve this for later